++++ Sign up for our newsletter and get a 10% discount on your next order ++++
++++ Sign up for the newsletter - get a 10% discount! ++++

This is how you can tie your pacifier holder

Here we show a possibility of how you can create a pacifier holder with pearls.

There are different ways, the important thing is that you make sure that your knots hold when you pull the pacifier holder properly!

Important to consider:
· Your pacifier holder must never be longer than 22cm (without clips) when you pull it. So count on e.g. the silicone ring will be longer than it is in round shape.
· The string used needs to have a minimum thickness of 1.5mm. We recommend our polyester cords or tie cords . Never use elastic thread for a pacifier holder.
· The beads used must be at least 6mm in diameter.
· Tie tightly and seal the ends carefully with a lighter for added security.
· Test the pacifier holder every time before you use it and tighten it properly to ensure that everything will hold!
· Also inform other people who will use the product about the safety and care instructions!

Please read more about safety and care advice on our page here !

For a beaded pacifier holder, you need a clip, optional beads, a silicone ring and a piece of polyester or tie string.

Begin by gently melting the ends of the string with a lighter and rolling them between your fingers. This will give you a point similar to a needle. Gently! It's hot!

Place a loop around the silicone ring.

Put a knot in front of the loop and pull tight!

Cut the short end about 5mm from the knot. Melt the end carefully with a lighter.

Press the melted end firmly against the knot with the lighter to seal your knot. Now you have a secure knot!

Now you string your first bead on the string. Silicone beads are so soft that you can pull it over the knot to hide it.

Now it both looks nice and is safe!

You can also use a wooden safety bead. The hole on it is a different size from both sides and you hide the knot in the larger hole.

Now you can thread all the beads on the string. Check that your letters end up in the right place.

Make sure that your pacifier holder is no longer than 22cm (without clips) when you pull it.

Now you can put a loop around the clip just like you did in the beginning as well.

Thread the end back through the last bead. This can be perceived as a bit fiddly, but you can thread it through together with the first thread, it will be a bit easier.

Tighten really hard so that the chain is really tight. It gets a little more relaxed later. Tie a knot in front of the last bead now.

For safety, we recommend a second knot. Tighten tight!

Cut the end about 5mm from the knot and do exactly as at the beginning. Melt the end (carefully so you don't touch the beads), press firmly against the knot.

Now you can drag the last bead over the knot to hide it again.

Also in this end you can use a safety bead. Bigger the hole towards the chain to then hide the knot. Otherwise, do the same.

Now your pacifier holder is ready! Pull it hard to make sure everything holds as it should!

Now your pacifier holder is ready! Pull it tight to make sure everything stays in place!

certifierad ehandel